-40%

AC Air Compressor Fits For Nissan Altima Sentra L4 2.5L 2007-2012 08 09 638784

$ 62.3

Availability: 904 in stock
  • Brand: Yitamotor
  • Manufacturer Part Number: F09OG1910
  • Warranty: 1 Year
  • Interchange Part Number: CO 10886C,67664,68664,638784,5512503,2011570
  • Notice: Sentra Fit SE-R Model Only
  • Return shipping will be paid by: Seller
  • Item must be returned within: 30 Days
  • Returns Accepted: Returns Accepted
  • Condition: New
  • Fitment: for 07 08 09 10 11 12 Altima sentra L4 2.5L Only
  • Pre-filled Oil: 100ml
  • Placement on Vehicle: Front
  • Refund will be given as: Money back or replacement (buyer's choice)

    Description

    Document
    NOTE: Each AC air compressor comes with about 100ML of Oil. You dont need to add oil additionally.
    Fitment:
    Fit for 20
    07-2012
    Nissan Altima
    L4
    2.5L Only
    Fit for
    2007-2012
    Nissan Sentra
    L4
    SE-R
    2.5L
    Only
    Interchange Part Number:
    10886C, 67664, 68664, 638784, 5512503, 2011570
    Installation Method
    Attention Please:
    Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
    1.
    Remove compressor:
    Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
    2.receiver drier or accumulator, orifice tube or expansion valve.
    3.Disconnect the negative battery cable.
    4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the  evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
    5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
    6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
    7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
    8.Evacuate the A/C system for a minimum of one hour.
    9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
    10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
    11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
    To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the
    Compatibility Table
    .
    Note:
    This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system.
    Please add refrigerant to 70-80% without filling up.
    There may be noise if the refrigerant is added too much.
    Package Included:
    1pc A/C Compressor
    WE ACCEPT THESE PAYMENT METHODS
    ( 10% sales tax will be applied for orders shipped to Washington state by state law )
    30 Days easy returns satisfaction guarantee.
    Items to be returned must be in original factory condition.
    Please enclose a note about item number and order id, your eBay ID and the reason of return.